A Garland Solar Installer That Works in the Details
We install, repair and look after solar systems on homes across the area. Most of what decides how long a system lasts is small: how a roof penetration is sealed, how wire is held off the shingles, how firmly a connector is seated. That is where we spend our attention.
Why the Small Parts Matter to Us
A solar array spends decades outdoors. The panels themselves are rarely the weak point. Trouble usually starts at the edges of the job: a lag bolt that missed the rafter, a conduit run left loose so it chatters in the wind, a wire bundle resting on hot shingles until its jacket wears through.
So we build our process around those edges. Mounts go into rafters we have located, not guessed at. Every penetration gets flashing and sealant suited to the roof it sits on. Wiring is clipped up under the modules, run in conduit where it is exposed, and given strain relief at each box. Labels go on before we leave, so anyone who opens a disconnect later knows exactly what they are looking at.
The same habits carry into the rest of our work. A battery storage install gets the same care with clearances and cable runs. A solar repair starts with finding the cause, not just swapping the part that failed. Panel cleaning is done with soft brushes and plain water, never a pressure washer that can push moisture past the seals.
What You Can Expect From Us
A site visit before any number
We look at your roof, your electrical panel and the shade around your home before we talk about system size. You get a written, line-item estimate that shows what is included and what could change it, such as a main panel upgrade or a permit requirement.
Photos of what we find
On repair calls and inspections we photograph what we see, from a scorched connector to a loose rail clamp. You see the problem for yourself and decide from there.
A straight repair-or-replace answer
If a fix will hold, we say so. If a part is near the end of its life, we tell you that too and explain why.
Permits, inspection and a tidy finish
We pull the permit, meet the inspector and handle the paperwork with your utility for interconnection. On the last day we walk the site with you, pick up offcuts and stray fasteners, and show you how to read your monitoring app.
Our Working Area
Our base is Garland, and we serve homes across the nearby area, including Rowlett, Sachse, Richardson, Murphy, Sunnyvale, Plano, Mesquite, Wylie, Rockwall and Balch Springs. Hail, months of summer heat and gusty spring storms are hard on rooftop equipment here, and that is a big reason we take mounting and wiring so seriously. You can read more about each town on the Service Areas page.
- Garland
- Rowlett
- Sachse
- Richardson
- Murphy
- Sunnyvale
- Plano
- Mesquite
- Wylie
- Rockwall
- Balch Springs
Talk Through Your Home's Solar With Us
Tell us what you have in mind, from a new array to a battery or a repair on an existing system. We will ask a few questions about your roof and your power use, then set a time to come take a look.